Services
Inloader transport
An inloader picks up a loaded rack between its frame and sets it down again at destination – without forklift or crane. This is common for flat glass on racks and for upright wall elements. Inloader transport can be organised via partners, by arrangement. What matters is that rack and vehicle match and the overall height stays within standard limits.
What matters
- Rack pick-up
- The vehicle reverses over the rack and lifts it – the rack stays loaded.
- Matching system
- Rack type, foot width and length must suit the inloader.
- Height
- Upright load plus vehicle must not exceed the permitted height.
- Set-down area
- At destination the rack needs level, firm ground and space to manoeuvre.
Planning questions
We clarify these points before quoting – the earlier they are known, the more precise the plan.
- Which racks do you use, and who owns them?
- How high and heavy is the loaded rack?
- Is there a level set-down area with room to manoeuvre at destination?
- Should empty racks be taken back?
What we need from you
- Rack type and dimensions
- Loaded weight
- Collection and set-down point
- Return of empty racks yes/no
Preparation: Installation, fitting and distribution inside the building are done by your team. We deliver to the agreed, accessible unloading point – unloading scope, waiting time and returns are set out in the quote.
What we do for you
What we organise
- Transport of building materials and elements within standard limits – from plant or merchant to site
- Delivery in the agreed slot, with notice and a fixed contact
- Crane truck, truck-mounted forklift or inloader can be organised via partners, by arrangement
Good to know
We organise scheduled transport of building materials and elements within the permitted vehicle, load and weight limits. If a shipment needs heavy or out-of-gauge transport because of its dimensions or loads, we plan it separately as an abnormal load.
How it works
- 01
Request
You send collection point, site, date and load details using the form below – anything unknown can stay open.
- 02
Review
We check with the partner whether rack system, height and set-down area suit the inloader.
- 03
Quote
You receive a quote with a clear scope: transport, delivery slot, unloading and any return runs.
- 04
Execution
Pick-up of the loaded rack at the plant, transport, set-down at the agreed point; empty racks taken back on request.
Questions and answers: Inloader transport
What is an inloader used for?
For racked loads transported upright – mainly flat glass and wall elements. The rack is picked up and set down as a whole.
Does every glass rack fit every inloader?
No. Rack type, dimensions and weight must suit the vehicle. Tell us the rack system and we check the combination.
What happens to the empty racks?
On request we take them back on a later run. Number and return point are agreed in the order.
Request
Request for this topic: Inloader transport
Three steps. Anything you do not know yet can be left open.
Details for planning
- Rack type and dimensions
- Loaded weight
- Collection and set-down point
- Return of empty racks yes/no